Below is an instructional video showing you how to apply your decals to a curved surface. In this example it is a metal drink bottle.
STEPS:
- Prepare your surface by cleaning it with our alcohol swab then drying with a clean cloth.
- Remove decal from backing paper. The clear application tape will pick up the decal when you take the backing paper off.
- Gently put decal on the surface where you wish it to be applied.
- Press down along the middle of the decal with your finger to keep it in place.
- Using your squeegee, press down from the centre of the decal (where you pressed down with your finger) outwards following the curve of the bottle.
- Do step 5 until the entire decal has been firmly pressed down.
- Gently peel back one corner of the clear application tape and remove fully.
- TA-DAH! your decal is applied.